The Chassis View is a graphical display of the Base Station, showing the installed components and their status. The display is refreshed every 15 seconds. Each of the installed modules (NPU, AUs, PIUs, PSUs) and the 10 fans of the AVU module is marked in either green (indicating that the component operates properly) or red (indicating a fault status).
For the NPU and installed AU(s), additional information and actions are available:
• The DATA and MGMT ports of the NPU are marked either green or red, indicating the Ethernet link status (up or down).
• Double-click on the NPU module to open the NPU general view page.
• Double-click on the DATA port to open the DATA Port configuration page.
• Double-click on the MGMT port to open the Management Port configuration page.
• In an AU, either 2 or 4 ODU connectors are shown, according to the installed AU IDU Type. Each of the ODU connectors (channels) are marked as follows:
- No marking (gray): The Admin Status is Disabled.
- Green: The Operational Status is Up, the Admin Status is Enabled.
- Red: The Operational Status is Down (fault), the Admin Status is Enabled.
Place the cursor on a connector to view the Downlink Frequency.
• Click once on an ODU connector (channel) to view relevant associations: A blue background will be added to the selected channel as well as to the Outdoor Unit and Radio Cluster associated with it (if applicable).
• Double-click on any of the ODU connectors (channels) to open the Channels configuration page for the applicable AU.
• Double-click on an AU module to open the AU general view page for the selected AU.
|
|